Chisel Hardies
This is a hot chisel with a square shank, which is held in place with the cutting edge facing upwards by placing it in an anvil 's hardy hole.
!

Anvil Devils
!
An Anvil Devil is a hard triangular piece of heat-treated steel that is used by farriers & blacksmiths for cutting or makeing V notches. You can place it on any flat surface. (or use in a GE Anvil Devil holder if you can still find one!)

Dimensions: 2-1/2 x 1/2 inch (63.5 x 13mm)

Item #: SAD

Pieh Tool Hardy (H13)
!

Pieh Legacy Collection!

Our hardy is drop forged from H13 tool steel. Beveled on both sides.
Made in USA exclusively for the Pieh Legacy Collection.

Available in 3/4, 7/8, 1 & 1-1/4" size shanks.

Item #: PTCH750, PTCH875, PTCH100 & PTCH125

Pieh Tool Hardy (H13), Bias Angle
!

Pieh Legacy Collection!

Our hardy is drop forged from H13 tool steel. Beveled only on one side-biased angle.
Made in USA exclusively for the Pieh Legacy Collection.

Available in 3/4, 7/8, 1 & 1-1/4" size shanks.

Item #: PTCH750-B, PTCH875-B, PTCH100-B & PTCH125-B

Peddinghaus Hardy, 7/8 inch
!
Special Order Item (However usually in stock)

The Peddinghaus Hardy fits snuggly in the hardy hole because of its taper.  The taper allows it to fit irregular shaped holes better. Made in Germany.

Shank is 7/8 in.

OAL is 5-3/4 in.  Hardy is 3-3/4 in. long.

Weight: 1,150 grams (2.5 pounds) 

Item #: 5058010000

G.E. Chisel Hardy
!
Available in 7/8 or 1 in shanks
Item #: GECH78 and GECH1

G.E. V-Style Hardy
!

Available in 7/8 or 1 in shanks

Item #: GEVH78 and GEVH1

Hot Cut Hardy, 1 inch
!
15 deg double sided angle, 5160 steel, 1-1/2 Hex Base. Made in USA

Item #: CDHC1