Rules

Steel or Brass rules, are essential in any shop when accuracy matters.

!

Pieh Traveler Rule, 6 inch

Don’t guess the measurement of complicated curves. Just roll the traveler along the curve and count the revolutions of the 6" wheel. Measures in inches and fractions.

Very handy for farriers as well blacksmiths.

Item #: PT6TR

!

Pieh Tool Steel Square, 6 inch

Features and Benefits

  • High quality 14 gauge, 304 stainless steel for durability and long life
  • All numbers and lines are laser etched.
  • Resists rust
  • Available in two styles; The Tri-Square model offers a clip on stand (as shown in photo) allowing for the ruler to stand up while measuring at a right angle.
!

Pieh Tool Round Protractor

Features and Benefits

  • Available in three diameters: 6", 12" and 24"
  • Made of 14 gauge, 304 stainless steel and successfully resist rust.
  • All numbers and lines are laser-etched into the tool.

This extremely handy tool is a must for those who need to layout accurate angles for fabrication, blacksmithing and woodworking among other situations.

The 24" is large enough to allow the layout of 1/4° increments

!

Pieh Tool Hook Rule

Quickly determine stock sizes without the hassle of a tape measure. The slots are used to determine the diameter of round stock, the size of square stock and the thickness of flat bar. The other side of the Hook Rule Gauge is used to determine the width of flat bar.

  • Made of 14 gauge, 304 stainless steel and successfully resist rust.
  • All numbers and lines are laser etched.

 

!

Pieh Tool Brass Folding Rule

 Pieh Legacy Collection!

2 foot, 1 fold brass ruler features measurements in the metric system as well as in inches.

Item #: PTBR

!

Lufkin Steel Folding Rule

The riveted joint has large side washer and a stop which brings rule to a firm stop when opened straight.
  • 3/4 in x 2 foot, 1/32 in thick, 1-fold, tempered steel rule
  • Legible, permanent, deeply etched black markings
  • Lower edge on one side graduated to 1/16ths 
  • Upper edge on other side to 1/8ths of an inch
  • Lower edge  has 75 degree circumference measurements in inches to 1/8ths for converting diameters directly to circumferential measurements

Item #: 86

!

Hoof Evener

The hoof evener is a simple and handy tool.  It is used for checking the toe length on shod feet, or for trimming evenly matched pairs of feet the easy way.  This is a labor saving device for the horseshoer or horseman. It enables the farrier to measure the length of the hoof wall at the toe immediately after trimming it, with the foot up and still in the trimming position. 

Horseman find it quick and easy to pick up a horse's foot and check toe length for growth, evenness, or for horse show classes that require measuring.  The unique curve at the end of the Hoof Evener make all this possible, and it takes only seconds! 

Comes with a clip attached to secure in your shirt pocket keeping the Hoof Evener handy. Simple precise instructions are included.

Item #: WHE

!

W-Brand Horseshoer/Blacksmith Ruler

Made of durable steel. One side measures 0-16 inches. The other side has 0 in the center measuring 8 inches in either direction. This handy ruler allows quick and accurate measuring in either direction making it a staple in your tool collection.

The reverse side of the ruler contains common shoe measurements for bar stock, bar stock weight in ounces per inch, a pritchel point guide and more!

Item #: WHR

!