Wedge Taper Flat Combination

Power Hammers LLC
Add to cart
  • Description
  • More

3.25" x 5.00" 20° included angle Any angle may be specified on this combination die set. Use the angle side to forge the point, then block it with the flat side. Highly efficient for multiple short tapers of a specific angle. Not for general tapering.

 

Item #: WTF

Swage dies are used for producing specific shapes in the middle( BFD) or on the ends (BEF) of solid round or square bar. Many times 2 operations are necessary when using the dies: the first uses the swage or spindle die to forge the shape into the desired location on the stock. The second operation uses a combination die to taper the remaining bar to the required sizes. In a production situation this sequence is most efficiently carried out with a second hammer, allowing the same heat to be used for both operations. The wide taper flat combinations ( WTF, WTD), while not technically a spindle die, have proven themselves superior in producing 3” or shorter pyramid points or straight tapers. Process times of around 15 seconds per part in 1” square A36 have been maintained over periods of several hours.